User guide

76
Updating the Software USB Connection
USB Connection
Updating the Software
General Information
With the aid of a data cable, the
firmware for your OpenPhone 27 can
be updated. For this, you will require
the following:
■ PC with Microsoft Windows and
a USB interface
■ A USB data cable for your Open-
Phone 27
■ CD with USB driver and updating
programme
You will find the required software
on the OpenCom 100’s system CD. A
USB data cable is part of the scope of
delivery of your OpenPhone 27.
Procedure
Carry out the following steps in or-
der to update the firmware of your
OpenPhone 27. The described USB
driver installation will also be re-
quired for the data communication
(see Data Communication starting on
page 78).
1. Under Windows 2000/XP you
must log on as an administrator.
2. Connect the USB port of your PC
to the OpenPhone 27 interface
using the data cable supplied.
3. The Windows operation system
shows the assistant for the
driver installation. Insert the
OpenCom 100’s system CD and
follow directions of the assist-
ant.
PC / Laptop
PC / Laptop