Specifications

System Hardware

INTER-TEL

CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005

Page 74 Keymaps

• Hunt Group Key: This button dials a hunt group pilot number when pressed and, if

assigned to a button with a lamp, will show the status of that hunt group.

• Individual Trunk Key: This button is associated with one trunk. It can be used for

placing outgoing calls, and for picking up calls on hold and answering incoming calls

on that trunk.

• Intercom (IC) Key: The button allows access to intercom channels for placing

and answering calls. If an button is not assigned, an intercom call will appear

under a Call button.

• Page Zone Key: A page zone button is programmed with one of the page access codes

(9600–9609 or 9600–9649 depending on the software version) for quick access to page

zones (0–9 or 0–49 respectively).

• Programmable Key: Up to 35 user-programmable buttons can be designated and given

default values in the keymap database. They can then be reprogrammed to enter any of

the trunk group access codes, extension numbers, or feature codes by the individual

endpoint users as desired. Or, they can be programmed as System or Station Speed Dial

bins, or as secondary extension buttons (see below). The endpoint user or programmer

can return the buttons to default values at any time.

• Secondary Extension Key: This type of button allows an endpoint user to have one-

button access to calls ringing or holding at another endpoint. It should be assigned to a

button with a lamp so that the secondary extension button can show the call status. If

desired, an endpoint can have several secondary extension buttons, each associated with

a different endpoint. For details, see page 137.

• SPKR Key: This button is used for turning the endpoint speaker or headset on and off.

• Speed Dial Keys: Each keymap can have up to 10 Speed Dial buttons. Each Speed Dial

button can be programmed by the endpoint user to dial one digit string. If assigned to a

button with a lamp, the lamp will show the status of an extension number if it is associ-

ated with that button.

• Trunk Group Key: These buttons are associated with specific trunk group access

codes and are used for placing outgoing calls on trunks in the selected trunk group. If

assigned to a button with a lamp, the lamp will be lit if all trunks in the trunk group are

in use.

• Undefined Key: Any button can be left undefined if it will not be needed. It can be

programmed, like a user-programmable button, as described above. If the endpoint user

or programmer returns the endpoint to default values, the button will return to being

“undefined.”

• Up Key: No further programming is necessary. This button can be used for scrolling

forward through displays. When the endpoint is idle, it can be used for adjusting vol-

ume, in place of the Volume button.

NOTE

The volume adjustment button on some endpoints also can be used for scrolling

through displays.