Specifications

Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Trunk Programming
Page 29
5. To Program A Trunk Group: Press or the TRUNK GROUP menu button. Then
program the trunk group, as follows:
a. The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-
ber of the trunk group to be programmed using one of the methods described on
page 27.
b. The display shows ENTER TRUNK GROUP OPTION. Select one of the following
options. To view the last three options on a display endpoint, press the arrow (<< or
>>) menu button at the bottom of the display.
Answer Access For Day Or Night Mode: To program the endpoint(s) that will
have answer access for this trunk group for day mode, press or the
ANS-
ACCESS DAY
menu button. To program for night mode, press or the ANS-
ACCESS NIGHT
menu button. When the display shows ENTER ENDPOINT
EXTENSION, perform the procedure described on the following page.
1.) Enter a endpoint extension using one of the methods described on page 27.
2.) The display shows the extension number and a Yes/No prompt. To include the
endpoint in the list, press or the YES menu button, followed by . Or, to
exclude the endpoint from the list, press or the NO menu button, followed
by .
3.) When the display returns to ENTER ENDPOINT EXTENSION, select
another extension number. Or, if finished programming the endpoint list, press
or ACCEPT to continue.
Ring-In For Day Or Night Mode: To program the endpoint that will have ring in
for this trunk group for day mode, press or the
RING-IN DAY menu button. To
program for night mode, press or the
RING-IN NIGHT menu button. When the
display shows ENTER ENDPOINT EXTENSION, enter endpoints into the list one
at a time as described above for Answer Access.
Toll Restriction: To program the toll restrictions for the trunk group, press or
the
TOLL RESTRICTION menu button. When the display shows TOLL RESTRIC-
TION OPTION, press the numbers that correspond to the toll restrictions you want
to program, as follows:
1.) COS for day or night mode: To program the toll restriction class of service
for day mode, press or the
COS DAY menu button. To program class of
service for night mode, press or the
COS NIGHT menu button. The display
shows SET DAY (or NIGHT) COS XX. If this is not the COS you want to
program, scroll to the correct COS by pressing the high end of the Volume
button or the
NEXT menu button to scroll forward, or press the low end of the
Volume button or the
PREVIOUS menu button to scroll backward. The default
COS numbers are listed below. (See page 126 for definitions. COS 01 is not
used for trunks.) When the correct COS is displayed, press or the
ON
menu button to enable the toll restriction. Or, press or the OFF menu but-
ton to disable it. If desired, repeat this step to program additional COS toll
restrictions. Then press or
ACCEPT to continue.
2.) Exempt from ARS: To program the Exempt from ARS option, press or
the
EXEMPT FROM ARS button. When the display shows EXEMPT FROM
COS 02 – Deny Area/Office COS 06 – Deny Equal Access
COS 03 – Deny Operator COS 07 – Deny Local Calls
COS 04 – Deny Toll Access COS 08 – Denied Numbers
COS 05 – Deny International COS 09 – Allowed Numbers
2
1
2
1
#
2
#
#
3
4
5
1
2
1
2
#
3