Specifications

Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Page 28 Trunk Programming
Answer Supervision: To program the answer supervision for the trunk, press or
the
ANS SUPERVISION menu button. When the display shows ANS SUPERVI-
SION OPTION, press or the
POLARITY REVERSE menu button for the polar-
ity-reversal supervision type. Or, press or the
VALID CALL menu button for
Valid Call timer supervision. Or, press or the
VALID + POLARITY menu button
for Valid Call timer with Polarity Reversal supervision. Then press or
ACCEPT
to continue.
Caller ID: To enable or disable Caller ID, press or the
CALLER ID menu but-
ton. When the display shows SET CALLER ID, press or
ON to enable the fea-
ture, or press or OFF to disable it. Then press or
ACCEPT to continue.
Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press
or the
HYBRID BALANCE menu button. When the display shows HYBRID BAL-
ANCE OPTION, press or the
NORMAL menu button, or press or the
SHORT menu button. Then press or ACCEPT to continue.
DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press or the
SIGNALING menu button. When the display shows ENTER SIG-
NALING OPTION, press or the
DTMF menu button, or press or the PULSE
menu button. Then press or ACCEPT to continue.
Trunk Group Number: To assign the trunk to a trunk group, press or the
TRUNK
GROUP
menu button. When the display shows ENTER TRUNK GRP EXTEN-
SION, enter the desired trunk group number using one of the methods described on
page 27.
Busy Trunk: To temporarily remove the trunk from service, press or the
BUSY
TRUNK
menu button. When the display shows MARK TRUNK BUSY, press
or the
ON menu button, or press or the OFF menu button. Then press or
ACCEPT to continue.
c. To exit, press or
ACCEPT to move backward through the prompts until you
reach the ENTER DATABASE OPTION prompt.
1
1
2
3
#
2
1
2
#
3
1 2
#
4
1 2
#
5
6
1
2
#
#