Specifications

Administrator Procedures

INTER-TEL

CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005

Page 18 Endpoint Programming

3.) When the correct COS is displayed, press or the ON menu button to

enable the toll restriction. Or, press or the

OFF menu button to disable it.

4.) If desired, repeat step cstep 2 and step cstep 3 to program additional COS toll

restrictions.

5.) Press or

ACCEPT to save the COS programming. The display shows

DATABASE UPDATED and then returns to the TOLL RESTRICTION

OPTION prompt.

6.) Press again to exit to the ENTER ENDPOINT OPTION prompt.

6. When the display shows ENTER ENDPOINT OPTION, press again to exit to the

ENTER ENDPOINT EXTENSION prompt. You can then program another endpoint by

repeating these steps or press or

ACCEPT once more to exit to the ENTER DATA-

BASE OPTION prompt.

7. When finished with all programming, press while the ENTER DATABASE

OPTION prompt is displayed. This ends the programming session.

8. If a system reset is required, the display shows ENTER SYS RESET OPTION. Do one

of the following:

— Delayed Reset: Press or the

DELAYED menu button to delay the reset. The dis-

play shows DELAYED RESET SCHEDULED. The system will be reset at the

pre-programmed time.

— Immediate Reset: Press or the

IMMEDIATE menu button to reset the system

now.

Table 5: Default COS Numbers

COS 02 – Deny Area/Office COS 06 – Deny Equal Access

COS 03 – Deny Operator COS 07 – Deny Local Calls

COS 04 – Deny Toll Access COS 08 – Denied Numbers

COS 05 – Deny International COS 09 – Allowed Numbers

NOTE A system reset will drop all calls in progress.