Specifications

Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 April 2005
Endpoint Programming
Page 17
5. The display shows ENTER ENDPOINT OPTION. Select one of the following:
a. Endpoint Flags: This option allows you to set the Administrator Endpoint, Atten-
dant, and House Phone flags. To select it, press or the
ENDPOINT FLAGS
menu button. There are three flags that can be programmed: Administrator, Atten-
dant, and House Phone. (However, you cannot program the Administrator flag for
your own endpoint or for a single line endpoint.) To program the flags, do the fol-
lowing:
1.) To scroll to the desired flag: Press the high end of the Volume button or
NEXT to scroll forward, or press the low end of the Volume button or PREVI-
OUS
to scroll backward.
2.) To enable or disable a displayed flag: Press or the
ON menu button to
enable the flag. Or, press or the OFF menu button to disable the flag.
3.) To save your programming when all flags are set correctly: Press or
ACCEPT to save the new flag settings. The display shows DATABASE
UPDATED and then returns to the ENTER ENDPOINT OPTION prompt.
4.) To exit without saving your changes: Press or
CANCEL to exit. The dis-
play shows NO UPDATE PERFORMED and then returns to the ENTER
ENDPOINT OPTION prompt.
b. Endpoint Information: This option allows you to select an Attendant for the end-
point or program the endpoint’s username. To select it, press or the
ENDPOINT
INFO
menu button. The display shows ENTER ENDPOINT INFO OPTION. Select
one of the following:
1.) Attendant: To assign an Attendant to serve this endpoint, press or the
ATTENDANT menu button. The display shows ENTER ATTENDANT
EXTENSION. Enter the desired extension number. When the circuit informa-
tion is displayed, press again to return to the ENTER ENDPOINT INFO
OPTION prompt. The display shows DATABASE UPDATED. (Or, to cancel
your entry, press or
CANCEL. The display shows NO UPDATE PER-
FORMED.)
2.) Username: To change the username of the endpoint, press or the
USER-
NAME menu button. The display shows ENTER USERNAME. Enter the new
name as described on page 14. (Or, to cancel your entry, press or
CAN-
CEL
. The display shows NO UPDATE PERFORMED.)
c. Toll Restriction: This option allows you to set the endpoint class of service for day
and/or night modes. To select it, press or the
TOLL RESTRICTION menu but-
ton. Then do the following:
1.) The display shows TOLL RESTRICTION OPTION. Press or the
COS
DAY
menu button to program day mode toll restriction. Or, press or the
COS NIGHT menu button to program night mode toll restriction.
2.) The display shows SET DAY (or NIGHT) COS XX. If this is not the COS
you want to program, scroll to the correct COS by pressing the high end of
the Volume button or
NEXT to scroll forward, or press the low end of the Vol-
ume button or
PREVIOUS to scroll backward. See page 126 for more infor-
mation abut COS.
The default COS numbers are provided in Table 5, following.
1
1
2
#
2
1
#
2
3
1
2