Specifications

Administrator Procedures

INTER-TEL

CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005

Page 16 Endpoint Programming

The endpoint Database Programming process is summarized in the flowchart shown on

page 19. For a Program Planning Sheet, refer to page 55.

To program endpoints:

1. While on-hook, enter the Program Database feature code (9932).

2. If a password is required, the display shows ENTER PASSWORD. Use the dialpad to

enter your 1-8 digit password and press . (If you enter an incorrect password or do

not press , the display shows INVALID PASSWORD.)

If a password is not required, skip this step.

3. The display shows ENTER DATABASE OPTION. (Display endpoints also show the

options: ENDPOINT, SYSTEM, and TRUNK.) Press or the

ENDPOINT menu but-

ton.

4. The display shows ENTER ENDPOINT EXTENSION. Enter the extension number of

the endpoint to be programmed using one of the following methods. (If you enter an

invalid extension number, you hear reorder tones and must try again.)

Enter a complete number: Enter the extension number using your dialpad. When the

circuit information is displayed, press again to continue.

Enter a partial number: Enter a partial extension number, then press , the high end

of the Volume button, or the

ACCEPT menu button. The display shows the extension

number, username and circuit number of the endpoint that most closely matches the

partial extension number. Press or

ACCEPT to program the displayed endpoint, or

scroll to another endpoint as described below.

Scroll through the numbers: To scroll through the extension number list, press the

high end of the Volume button or

NEXT to scroll forward, or press the low end of the

Volume button or

PREVIOUS to scroll backward. When the desired extension number

is displayed, press or

ACCEPT to continue.

NOTE

If necessary, at any time during the following procedure you can press the aster-

isk ( ) or Speaker button to cancel programming and discard any unsaved

changes.