Specifications

Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Placing the System in Night Mode
Page 11
System Administrator Procedures
If your endpoint is designated as a system administrator endpoint, you can perform the follow-
ing procedures:
• Place the local node or other nodes in the network in night or day mode.
• Set the date and time of the local node.
• Set the network date and time and resynchronize clocks in the network.
• Make database changes (see page 13 for a list of programming areas).
• Enable, disable, and reset local and off-node call processing application modems.
• Program System Speed Dial numbers on the local node.
• Receive and clear displayed system and network alarms.
• Use diagnostic mode features:
— Freeze and unfreeze the database history for the local node or any node in the net-
work using programmed freeze zones.
— Print error logs.
— Seize specific devices for troubleshooting purposes.
Any Inter-Tel endpoint can be programmed to be an Administrator endpoint by the database
programmer or by another Administrator endpoint.
If a non-Administrator endpoint user attempts to use the Administrator features, the user will
hear reorder tones, and the display will show CANNOT ACCESS RESERVED FEATURE.
Placing the System in Night Mode
An Administrator endpoint can place the local node in day or night mode. The day/night mode
determines which lists the system will use for trunk access, toll restriction, etc.
To turn night mode on or off:
While on-hook, enter the Night Ring On/Off feature code (9860). You hear a single
confirmation tone. The display shows NIGHT MODE IS ON (or OFF). If night mode
was turned on, the display shows THE SYSTEM IS IN NIGHT MODE until day mode
is turned on.
Placing Nodes in Day or Night Mode
An Administrator endpoint can place one or more nodes in day or night mode. The day/night
mode determines which lists the system will use for trunk access, toll restriction, etc.
The network determines the day/night mode status of a call based on the day/night mode status
of the node where the trunk resides.
To turn night mode on:
1. While on-hook, enter the Enable Network Night feature code (9861).
2. When you are prompted to enter a node number., enter 01–63 for the desired node num-
ber. To select all nodes, enter 00.
You hear a single confirmation tone. The display shows NIGHT MODE IS ON. Then
the display shows NODE X IS IN NIGHT MODE until day mode is turned on.
NOTE A single line endpoint cannot be used as an Administrator endpoint.