Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Page 200 Using the Last Number Dialed Feature
To make a page:
1. Lift the handset.
2. Inter-Tel endpoints—Press the PAGE button, or enter the Page feature code (7). The
display shows SELECT PAGE ZONE # (0–9).
Single line endpoints—Enter the Page feature code (7).
3. Enter the zone code (0–9 or 0–49) for the desired zone.
4. After the single progress tone, make your page before the Page timer expires. If you
hear reorder tones, and the display shows PAGE ZONE NOT PROGRAMMED, there
are no stations in the selected page zone. If the display shows PAGE ZONE BUSY
TRY AGAIN LATER, the necessary system resources are busy or the paging zone is
being used by another station. Users cannot camp on to or queue the paging system.
5. Hang up.
Remove from Paging
An Inter-Tel endpoint user can prevent the endpoint from receiving pages or allow it to receive
pages again using these feature codes. If the endpoint is assigned to more than one page zone,
all zones are removed or replaced; the user cannot toggle individual zones.
To halt or enable zone pages:
1. While on- or off-hook, enter the Page Receive On/Off feature code (325) to prevent the
endpoint from receiving pages. You hear a confirmation tone and the display shows
PAGE RECEIVE ON (or OFF).
2. If off-hook, hang up.
Do-Not-Disturb
Placing a station in Do-Not-Disturb halts all pages, incoming intercom calls, camped-on calls,
and transferred calls to that station. Queue callbacks, recalls, and direct ring-in calls are not
blocked. Another user calling the station while it is in Do-Not-Disturb hears a repeating signal
of four fast tones and a pause (display endpoints show the Do-Not-Disturb message); the user
cannot camp on, but can queue or leave a message at the station.
If desired, individual stations can be prevented from using Do-Not-Disturb by disabling the
Do-Not-Disturb option in the database.
If a hunt group station is in Do-Not-Disturb, calls to the user’s hunt group do not cause the
endpoint to ring, but the individual trunk button will flash if all other stations in the hunt group
are busy, forwarded, have hunt group remove enabled, or are in Do-Not-Disturb. Hunt group
announcement stations and overflow stations can use Do-Not-Disturb to block hunt group calls
by using Do-Not-Disturb.
Inter-Tel endpoints may be given Do-Not-Disturb override permission. These stations, when
reaching a station in Do-Not-Disturb, can enter the Do-Not-Disturb Override feature code
(373) to place a non-handsfree intercom call to the station. Single line endpoints cannot be
enabled to use the Do-Not-Disturb Override feature.
When a station is placed in DND, the user may select one of 20 system-stored messages that
will appear on the top line of the display (unless Do-Not-Disturb is enabled while the user is on
a call or off-hook, in which case message 1 is automatically selected). When a station in Do-
Not-Disturb is called by a display endpoint user, the caller sees the selected message.
NOTE
Direct ring-in calls forwarded to a station in DND will ring according to the DND
rules.