Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Page 198 Using the Last Number Saved Feature
Using the Last Number Saved Feature
Use the following procedures to save and redial numbers at stations that are programmed to
use the Last Number Saved feature.
To save a number on a station programmed for last number saved:
Inter-Tel endpoints: While the endpoint is idle or while listening to intercom dial
tone, press the button, or press the Special button and enter the Redial feature
code (380). You hear a confirmation tone, and the display shows LAST OUTSIDE
NUMBER SAVED.
Single line endpoints: Lift the handset and enter the Redial feature code (380). When
you hear the confirmation tone, hang up.
To redial a number (last number saved):
Inter-Tel endpoints: While on a call or after selecting a trunk, press the but-
ton, or press the Special button and enter the Redial feature code (380). Refer to the
chart on the previous page to determine which trunk is selected. The saved phone num-
ber is dialed.
Single line endpoints: While on a call or after selecting a trunk, hookflash and then
enter the Redial feature code (380). Refer to the chart on the previous page to deter-
mine which trunk is selected. The saved phone number is dialed.
Using the Last Number Dialed Feature
Use the following procedure to redial numbers at stations that are programmed to use the Last
Number Dialed feature.
To redial a number (last number dialed):
Inter-Tel endpoints: While on- or off-hook, press the button, or press the Spe-
cial button and enter the Redial feature code (380). Refer to the chart on the previous
page to determine which trunk is selected and which digits are dialed.
Single line endpoints: Lift the handset or hookflash. Then enter the Redial feature
code (380). Refer to the chart on the previous page to determine which trunk is
selected and which digits are dialed.
Redirect Call
The Redirect Call feature code is located under System/Devices and Feature Codes/Feature
Codes. The Redirect Call Feature (feature code 331) allows Inter-Tel endpoint users to route
ringing outside, intercom, and camped on calls to another station, hunt group, or outside num-
ber. Routing of the redirected call is still subject to trunk and toll restrictions. This feature pro-
vides these options in addition to the currently available options which allow the station user to
redirect calls to Voice Mail or Do-Not-Disturb.
The Redirect Ringing Call feature does not require premium features. Some specific aspects of
this feature are described below.
• Calls are redirected using the feature code 331. This code is entered, followed by the
desired destination number.
• If the endpoint receiving the redirected call is a display endpoint, it will show EXT
XXXX FWD FROM EXT XXXX just as it does for a manually forwarded call.
NOTE The saved number is replaced each time you repeat this procedure.
REDIAL
REDIAL
REDIAL