Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Dialing Station Speed Dial Numbers
Page 195
4. If desired, press the high end of the Volume button or the
NEXT button to scroll forward
alphabetically through the directory or press the low end of the Volume button or the
PREVIOUS button to scroll backward.
5. Do one of the following:
• To store the selected number in a Station Speed Dial location: Press the desired
Speed Dial button. You hear confirmation tone when the number is accepted.
• To automatically dial a displayed extension number: Press , the but-
ton, or the
ACCEPT button. (If an intercom call is camped on and the but-
ton is lit, pressing the button answers the waiting call and terminates the
Directory feature.)
• To dial a displayed outside number: Press , the
CALL menu button, or a Call
button. The system automatically dials the number using your programmed outgo-
ing access code.
• To dial a displayed feature code: Press or the
ACCEPT button. The system
automatically dials the feature code.
• To search for another name or number: Repeat the procedure starting at step 3.
House Phone
This feature provides users with the ability to place a pre-designated intercom or outside call
simply by lifting the handset (or pressing the Speaker button, if using an Inter-Tel endpoint) on
a designated House Phone. In a network, the house phone can be programmed to dial an off-
node device. There are several applications for this feature, such as:
• Courtesy paging endpoint: Visitors hear pages instructing them to pick up the house
phone (such as the paging endpoints used in airport terminals). When they lift the hand-
set, they are connected to a pre-programmed station user who can give them a message
or connect them to a call.
• Emergency endpoint: The House Phone can be programmed to automatically dial the
Emergency Call feature code (default is 911, 999 in Europe). This could save time in an
emergency.
• Service endpoint: Customers can use the House Phone(s) to place orders or receive
special services from the lobby. For example, the House Phone would automatically
dial the extension number of a service representative (or hunt group number of the ser-
vice department).
• Intercom network: House Phones could be placed in specific locations throughout a
building (such as examination rooms in a doctor’s office) and could be programmed to
call a specific endpoint or group of endpoints (such as nurses’ stations).
Any endpoint may be designated as a House Phone in Database Programming. However, this
feature is usually assigned to single line endpoints. The primary Attendant should not be desig-
nated as a House Phone.
The number dialed by the House Phone is determined by the station’s Speed Dial program-
ming. The number programmed through the database or in Station Speed Dial location 0 is
automatically dialed during day mode, and the number in location 1 is dialed during night
mode. This number can be either an extension number or an outside phone number. If it is an
outside number, it must be preceded with a trunk access code (and a pause if necessary).
Once the House Phone status has been programmed, the Speed Dial number can only be
changed while on-hook (if it is an Inter-Tel endpoint) or through individual endpoint informa-
tion (special purpose endpoint) programming because lifting the handset will cause the end-
point to dial the designated number.
#
IC
IC
IC
#
#