Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Viewing Station Speed Dial Numbers
Page 191
To program Station Speed Dial numbers at a non-display endpoint:.
1. While on-hook, enter the Program Station Speed Dial feature code (383).
2. Press the Speed Dial button to be programmed or dial the Speed Dial location code (0–
9). If you hear reorder tones, you entered an invalid speed dial location code; try again.
3. Do one of the following:
• To enter or change a number: Dial the extension number or phone number (up
to 16 digits, including pauses and hookflashes) to be stored. To include *, #, a
hookflash, or a pause in the number, press the Special button once for an asterisk
(*), twice for a pound (#), three times for a hookflash, or four times for a pause.
You can enter more than one *, #, or hookflash in a row by pressing the
button to move to the next character (not necessary after pauses). If you make a
mistake, press to back up and erase, or press or
CANCEL to leave the
number unchanged; then start over at step 1.
• To erase an existing number and leave it blank: press until the number
is erased.
4. Press to exit. Repeat these steps for each additional number to be stored.
To program Station Speed Dial numbers at a single line endpoint:.
1. Lift the handset and enter the Program Station Speed Dial feature code (383). You hear
a confirmation tone.
2. Dial the Speed Dial location code (0–9). If you hear reorder tones, you entered an
invalid speed dial location code; try again.
3. Do one of the following:
• To enter or change a number: Dial the extension number or phone number (up
to 16 digits, including pauses and hookflashes) to be stored. To include *, #, a
hookflash, or a pause in the number, hookflash once for an asterisk (*), twice for
a pound (#), three times for a hookflash, or four times for a pause. If you make a
mistake, press to leave the number unchanged; then start over at step 1.
• To erase an existing number and leave it blank: Overwrite the existing number
by entering only a hookflash as the new number.
4. Hang up to exit. Repeat these steps for each additional number to be stored.
Viewing Station Speed Dial Numbers
To view the contents of a Speed Dial button (on a display endpoint):
1. While on-hook, enter the Review Keys feature code (396). The display shows PRESS
THE KEY TO REVIEW. Press the desired Speed Dial button. The display shows the
currently stored number and name.
2. After viewing the number, press the Speaker button, , or to exit, or wait for the
display to return to date and time.
NOTE
If you make a mistake, press or CANCEL; then start over. The number in
memory remains unchanged. Or, use the button to backspace.
NOTE
If you make a mistake, press ; then start over. The number in memory
remains unchanged.
MUTE
FWD
MUTE
MUTE
#
#