Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Volume Controls
Page 135
Inter-Tel Endpoint Features
The following sections describe how to use Inter-Tel endpoint features.
Volume Controls
On Inter-Tel endpoints, volume is controlled in the following ways:
• On Model 8600, 8620/8622, and 8660 endpoints, illustrations of speakers ( and )
represent higher and lower volume levels. Press the end of the button to lower the
volume and the end of the button to raise the volume.
• The other Inter-Tel endpoints have separate VOL UP and VOL DOWN keys.
To change volumes on an Inter-Tel endpoint:
Press the appropriate button to raise or lower the volume, using one of the procedures listed
below. A confirmation tone will alert you when you have reached the highest or lowest possi-
ble volume. On display endpoints, the display shows VOLUME LEVEL X. The “X” repre-
sents the level and changes as the volume is raised or lowered.
• To change handset intercom voice volume: Adjust the volume while on an off-hook
(handset) intercom call.
• To change handsfree intercom voice and paging volume: Adjust the volume while on
an on-hook (speakerphone) intercom call.
• To change handset outside call voice volume: Adjust the volume while on an off-
hook (handset) outside call.
• To change handsfree outside call voice volume: Adjust the volume while on an on-
hook (speakerphone) outside call.
• To change headset intercom voice volume: (Model 8620 and 8660 endpoints Only)
Adjust the volume while using the headset and on an intercom call.
• To change background music volume: Adjust the volume while listening to music
through the endpoint speaker. The selected background music volume level is automati-
cally saved.
• To change alerting tone (ring tone) volume: Adjust the volume while the endpoint is
ringing or idle. OR, while on-hook, press both edges of the Volume button to hear the
currently programmed volume. Then adjust the volume.
• To change handset progress tone volume: Press the desired arrow while listening to
intercom dial tone through the handset.
• To change speakerphone progress tone volume: Press the desired arrow while listen-
ing to intercom dial tone through the speakerphone.
To return an Inter-Tel endpoint to default volume levels:
While on- or off-hook, enter the Default Endpoint feature code (394). If off-hook, hang up.
The display shows ENDPOINT DEFAULTED.
NOTE
Entering this feature code also cancels Do-Not-Disturb, manual call forwarding,
background music, ring intercom always, all calls following account code, head-
set mode, and queue requests; and restores handsfree mode, pages, hunt group
calls, and system forwarding.