Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Endpoint Feature Codes
Page 97
Page 7 When followed by a paging zone code (0–9 or 0–49), it allows
announcements to be made through endpoint speakers and any
external paging speakers in the page zone.
Page On/Off 325 (Inter-Tel endpoints Only) Halts pages through the endpoint
speaker or allows them to be received again.
Program Buttons 397 (Inter-Tel endpoints Only) User-programmable feature buttons and
Station Speed Dial buttons can be programmed using this feature
code.
Program Endpoint Password 392 The endpoint password is used for the Remote Programming fea-
ture. The password can be changed by entering the Program End-
point Password feature code at the endpoint or when using the
Remote Programming feature.
Queue Request 6 Requests (or cancels) an automatic callback when a busy trunk or
endpoint becomes available.
Record-A-Call 385 If the system is programmed with a Record-A-Call application, the
endpoints can be programmed to use the Record-A-Call feature. It
allows users to enter a feature code whenever they want to record
an ongoing call in their designated Record-A-Call mailbox. Users
can retrieve the recorded messages later, just as they would any
other mailbox messages.
Redial 380 Redials the last outside phone number dialed or saved at the end-
point (up to 48 digits). Also used to save numbers at endpoints pro-
grammed for last number saved. (Inter-Tel endpoints use the
REDIAL button.)
Redirect Call 331 This feature allows the endpoint user to route ringing outside, inter-
com, and camped on calls to another endpoint, hunt group, or out-
side number. Routing of the redirected call is still subject to trunk
and toll restrictions. This feature provides these options in addition
to the currently available options which allow the endpoint user to
redirect calls to Voice Mail or Do-Not-Disturb. The Redirect Ringing
Call feature does not require any premium features.
Reminder Message
Reminder Message Cancel
305
306
(Inter-Tel endpoints Only) The endpoint user can set reminder mes-
sages that signal the endpoint at specific times. Or, the user can
cancel all reminder messages for the endpoint.
Remote Programming 359 Allows a user to place an endpoint in DND mode, forward the end-
point’s calls, or change the password; either from another endpoint
or through DISA.
Reverse Transfer (Call Pick-Up) 4 Picks up a call ringing or holding at an endpoint or hunt group
Review Keys 396 (Inter-Tel endpoints Only) User-programmable feature buttons and
Station Speed Dial buttons can be viewed using this feature code.
Ring Intercom Always On/Off 377 Enables/disables the feature that allows the endpoint to always
place private (non-handsfree) intercom calls.
Ring Tone Selection 398 (Inter-Tel endpoints Only) Selects the type of ringing alert tone that
will be heard from the endpoint.
Routing Off 304 Disables System OAI Offering Control for third-party applications.
(This feature requires you to enter a password.) Once you disable
routing, you cannot enable it again (i.e., only the third-party applica-
tion can enable routing).
Table 18. Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE DEFINITION