Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Page 96 Endpoint Feature Codes
Do-Not-Disturb Override 373 (Inter-Tel endpoints Only) If enabled in the database, allows the
endpoint user to break through another endpoint’s Do-Not-Disturb
mode when placing an intercom call
Feature Key Default 395 (Inter-Tel endpoints Only) endpoints have user-programmable fea-
ture buttons that can be set to enter feature codes. This code
returns the user-programmable buttons to the database default val-
ues.
Group Listen 312 (Inter-Tel endpoints Only) Allows a user to transmit a conversation
over the endpoint speaker while in handset or headset mode
Handsfree On/Off 319 (Inter-Tel endpoints Only) Disables/enables the endpoint’s hands-
free intercom answering. Incoming intercom calls ring as private
calls if handsfree answering is disabled.
Headset Enable
Headset Disable
Headset On/Off
315
316
317
(Inter-Tel endpoints Only) The enable code signals the system that
a headset has been connected to the endpoint. The disable code
returns the endpoint to normal operation. The on/off feature code
can be used to toggle the feature on or off.
Hold – Individual 336 Places a call on hold so that it can be picked up directly at that
endpoint or through a reverse transfer from any other endpoint.
(Inter-Tel endpoints use the HOLD button.)
Hold – System 335 Places an outside call on system hold. It can be picked up directly
at any endpoint that has an individual trunk button and has
allowed-answer and/or outgoing access for that trunk, or by the
endpoint that placed it on hold. (If used on conference or intercom
calls, the system places the call on individual hold.)
Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/Replace
322
323
324
Removes the endpoint from its assigned hunt group(s) or places it
in again. Does not affect non-hunt group calls. The remove/replace
feature code can be used to toggle the feature.
LCD Contrast Adjustment 303 (Model 8620, 8622, 8660, or 8662) Adjusts the LCD contrast on the
display. The endpoint must be idle to use this feature.
Message 365 This feature code is used for leaving and retrieving a message
waiting indication at a called endpoint or the called endpoint’s mes-
sage center. Depending on how the message was left, the called
endpoint user either retrieves the message from his/her message
center or from the endpoint that left the message. (Inter-Tel end-
points use the MSG button.)
Message – Cancel 366 Allows the endpoint user to cancel a message waiting indication
that he or she left at another endpoint.
Message – Cancel Current 368 Cancels a message waiting indication that is waiting at the endpoint
without requiring the user to respond to it. (Inter-Tel endpoints can
use the asterisk [*] button while viewing the message.)
Message – Silent 367 Leaves a message waiting indication at a endpoint without first
placing an intercom call.
Mute On/Off 314 (Inter-Tel endpoints Only) Turns the microphone on or off during a
call. If muted, the endpoint user can hear the other party, but the
party cannot hear the endpoint user. (Inter-Tel endpoints can also
use the MUTE button.)
Table 18. Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE DEFINITION