Specifications

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.0 – April 2005
Endpoint Feature Codes
Page 95
Call Forward If Busy 357 Immediately forwards all calls to another endpoint or to an outside
endpoint number when the endpoint is in use.
Call Forward If No Answer 356 Forwards all calls to another endpoint or to an outside endpoint
number if not answered within a predetermined time.
Call Forward If No Answer/Busy 358 Forwards all calls to another endpoint or to an outside endpoint
number if not answered within a predetermined amount of time, or
immediately if the endpoint is in use.
Change Language 301 An endpoint user can change the assigned language for the end-
point by entering the Change Language feature code while the
endpoint is idle.
CO Hookflash 330 Sends a timed hookflash over the trunk while on an outside call
(includes conference calls).
Conference 5 Connects from three to four parties in a conference. A conference
consists of any combination of inside and outside parties. (Inter-Tel
endpoints use the CNF button.)
Data 340 (Inter-Tel endpoints Only) Allows operation of a data device
attached to an endpoint that has a PC Data Port Module and a
Modem Data Port Module (also requires a modem-equipped data
device).
Default Endpoint 394 This single feature code cancels account codes for all calls follow-
ing, Do-Not-Disturb, manual call forwarding, background music,
ring intercom always, and queue requests; restores handsfree
mode, pages, hunt group calls, and system forwarding; and returns
endpoint volumes to default values.
Directories 307 (Display endpoints Only) Allows display endpoint users to search
for extension numbers or System Speed Dial numbers. The number
can then be dialed, if desired.
Display Outside Party Name On/
Off
379 (Display endpoints Only) When the endpoint user enters this fea-
ture code, while connected to a CO call that has outside party
name information, the display will toggle between the caller’s name
and number. If there is no outside party name or the Expanded CO
Call Information On Displays flag is disabled, the user will hear a
burst of reorder tone and see the CANNOT ACCESS FEATURE
display. If the Display Outside Party Name On/Off feature code is
programmed in a user programmable button with a lamp, the lamp
will be lit when the outside party name is enabled and off when the
outside party number is enabled.
Display Time/Date (ITP)
Show IP Address (SIP)
300 (Display endpoints Only) Temporarily displays the system date and
time, username, and extension number during a call or when other
displays are shown.
Feature code 300 displays the IP Address of an endpoint if it is in
SIP mode (see page 80).
Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off
370
371
372
The Do-Not-Disturb feature code halts all intercom calls, transferred
calls, and pages to the endpoint. The Cancel code returns the end-
point to normal operation. The on/off code can be used to turn Do-
Not-Disturb on or off. (Inter-Tel endpoints use the DND button.)
Table 18. Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE DEFINITION