User guide

Using Attendant Console
Page 72 Mitel
®
Attendant Console User Guide – Issue 3.2, September 2009
d. Move the desired toll restrictions from the Exclude Toll Restriction list to the Include
Toll Restriction list, as follows:
o Highlight a toll restriction in the Exclude list and click Add-> to move it to the
Include list.
o Highlight a toll restriction in the Include list and click <-Remove to move it to
the Exclude list.
o Click Add All-> to move all restrictions to the Include list.
o Click <-Remove All to move all restrictions to the Exclude list.
e. When the Include Toll Restrictions list is correct, click OK to save your changes and
exit. Or to exit without saving changes, click Cancel.
DND/Reminder Tab
To Program Do-Not-Disturb and Reminder Messages:
In the DND/Reminder tab you can delete or change the texts for the Do-Not-Disturb and
Reminder messages. The new messages can be any value (up to 16 characters).
When the system has a programmed Primary and Secondary Language, the system has
default messages in both languages. (Available languages are American English, British
English, Spanish, and Japanese.)
The default Do-Not-Disturb and Reminder messages are shown in the Program Planning
Sheet on pages 75 and 76.
NOTE
The Attendant Console can be used to program only the Primary Language
messages. To enter Japanese characters, you must use your keyset.