User guide

Mitel
®
Attendant Console User Guide – Issue 3.2, September 2009 Page 15
Getting Started
Night Mode Tab
The Night Mode tab, shown below, allows an Administrator to configure what will happen when
the nodes are put in Night Mode. This tab also shows the night mode status of each node for all
users.
• Night Mode Setup:
o Put all nodes in night mode: All nodes connected to the OAI Server are put in and
out of night mode.
o Put only my node in night mode: Only the operator’s node is put in and out of night
mode.
o Put selected nodes in night mode: Allows you to choose what nodes to put in and
out of night mode from a list. The list will contain all the nodes that the Attendant
Console is communicating with and their locations.
To select the desired nodes:
Check Put selected nodes in night mode, the Node list becomes editable, as shown
below. Check the desired nodes and click OK.
NOTE
Only an Administrator can perform the night mode configuration and on and off. All
users have the ability to view the night mode status but does not be allowed to put
nodes in or out of night mode.