User guide

Page 33
Administrator Procedures
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
Trunk Programming
6. To Program A Trunk Group: Press or the TRUNK GROUP menu button. Then
program the trunk group, as follows:
• The display shows ENTER TRUNK GRP EXTENSION. Enter the extension
number of the trunk group to be programmed using one of the methods described
on page 31.
• The display shows ENTER TRUNK GROUP OPTION. Select one of the follow-
ing options. To view the last three options on a display endpoint, press the arrow
(<< or >>) menu button at the bottom of the display.
– Answer Access For Day Or Night Mode: To program the station(s) that will
have answer access for this trunk group for day mode, press or the ANS-
ACCESS DAY menu button. To program for night mode, press or the
ANS-ACCESS NIGHT menu button. When the display shows ENTER
STATION EXTENSION, perform the procedure described on the following
page.
Enter a station extension using one of the methods described on page 31. The
display shows the extension number and a Yes/No prompt. Press or the
YES menu button, followed by , to include the station in the list. Or, press
or the NO menu button, followed by , to exclude the station. When the
display returns to ENTER STATION EXTENSION, select another extension
number. Or, if finished programming the station list, press or ACCEPT
to continue.
– Ring-In For Day Or Night Mode: To program the station that will have ring
in for this trunk group for day mode, press or the RING-IN DAY menu
button. To program for night mode, press or the RING-IN NIGHT menu
button. When the display shows ENTER STATION EXTENSION, enter sta-
tions into the list one at a time as described above for Answer Access.
– Toll Restriction: To program the toll restrictions for the trunk group, press
or the TOLL RESTRICTION menu button. When the display shows
TOLL RESTRICTION OPTION, press the numbers that correspond to the
toll restrictions you want to program, as follows:
– COS for day or night mode: To program the toll restriction class of service
for day mode, press or the COS DAY menu button. To program class of
service for night mode, press or the COS NIGHT menu button. The dis-
play shows SET DAY (or NIGHT) COS XX. If this is not the COS you want
to program, scroll to the correct COS by pressing the high end of the volume
button or the NEXT menu button to scroll forward, or press the low end of
the volume button or the PREVIOUS menu button to scroll backward. The
default COS numbers are listed below. (See page 161 for definitions. COS 01
is not used for trunks.) When the correct COS is displayed, press or the
ON menu button to enable the toll restriction. Or, press or the OFF menu
button to disable it. If desired, repeat this step to program additional COS toll
restrictions. Then press or ACCEPT to continue.
2
1
2
1
#
2
#
#
3
4
5
1
2
1
2
#