User guide

Page 32

Administrator Procedures

Inter-Tel

Axxess

Administrator Guide — Issue 11.0, May 2008

Trunk Programming

5. To Program an Individual Trunk: Press or the INDIVIDUAL TRUNK menu but-

ton. Then program trunk options as follows:

• The display shows ENTER TRUNK EXTENSION. Enter the extension number of

the trunk to be programmed using one of the methods described on page 31.

• The display shows INDIVIDUAL TRUNK OPTION. Enter one of the following

options. To view the last two options on a display endpoint, press the arrow (<< or

>>) menu button at the bottom of the display.

– Answer Supervision: To program the answer supervision for the trunk, press

or the ANS SUPERVISION menu button. When the display shows

ANS SUPERVISION OPTION, press or the POLARITY REVERSE

menu button for the polarity-reversal supervision type. Or, press or the

VALID CALL menu button for Valid Call timer supervision. Or, press or

the VALID + POLARITY menu button for Valid Call timer with Polarity

Reversal supervision. Press or ACCEPT to continue.

– Caller ID: To enable or disable Caller ID, press or the CALLER ID

menu button. When the display shows SET CALLER ID, press or ON to

enable the feature, or press or OFF to disable it. Then press or

ACCEPT to continue.

– Hybrid Balance: To set the hybrid balance of the trunk to normal or short,

press or the HYBRID BALANCE menu button. When the display shows

HYBRID BALANCE OPTION, press or the NORMAL menu button, or

press or the SHORT menu button. Then press or ACCEPT to con-

tinue.

– DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signal-

ing, press or the SIGNALING menu button. When the display shows

ENTER SIGNALING OPTION, press or the DTMF menu button, or

press or the PULSE menu button. Then press or ACCEPT to con-

tinue.

– Trunk Group Number: To assign the trunk to a trunk group, press or the

TRUNK GROUP menu button. When the display shows ENTER TRUNK

GRP EXTENSION, enter the desired trunk group number using one of the

methods described on page 31.

– Busy Trunk: To temporarily remove the trunk from service, press or the

BUSY TRUNK menu button. When the display shows MARK TRUNK

BUSY, press or the ON menu button, or press or the OFF menu but-

ton. Then press or ACCEPT to continue.

• To exit, press or ACCEPT

to move backward through the prompts until you

reach the ENTER DATABASE OPTION prompt.