User guide

Page 122
System Features
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
Station Feature Codes
Program Station Password 392 The Station password is used for the Remote Programming fea-
ture. The password can be changed by entering the Program Sta-
tion Password feature code at the station or when using the
Remote Programming feature.
Queue Request 6 Requests (or cancels) an automatic callback when a busy trunk or
station becomes available. (Analog endpoints have a default
QUEUE button.)
Record-A-Call 385 If the system is programmed with a Record-A-Call application, the
stations can be programmed to use the Record-A-Call feature. It
allows users to enter a feature code whenever they want to record
an ongoing call in their designated Record-A-Call mailbox. Users
can retrieve the recorded messages later, just as they would any
other mailbox messages.
Redial 380 Redials the last outside telephone number dialed or saved at the
station (up to 48 digits). Also used to save numbers at endpoints
programmed for last number saved. (Inter-Tel endpoints use the
REDIAL button.)
Redirect Call 331 This feature allows the endpoint user to route ringing outside, inter-
com, and camped on calls to another station, hunt group, or out-
side number. Routing of the redirected call is still subject to trunk
and toll restrictions. This feature provides these options in addition
to the currently available options which allow the station user to
redirect calls to Voice Mail or Do-Not-Disturb. The Redirect Ringing
Call feature does not require any premium feature licenses.
Reminder Message
Reminder Message Cancel
305
306
(Inter-Tel endpoints only) The endpoint user can set reminder mes-
sages that signal the station at specific times. Or, the user can
cancel all reminder messages for the station.
Remote Programming 359 Allows a user to place an endpoint in DND mode, forward the sta-
tion’s calls, or change the password; either from another station or
through DISA.
Reverse Transfer (Call Pick-Up) 4 Picks up a call ringing or holding at a station or hunt group
Review Keys 396 (Inter-Tel endpoints only) User-programmable feature buttons and
station speed-dial buttons can be viewed using this feature code.
Ring Intercom Always On/Off 377 Enables/disables the feature that allows the station to always place
private (non-handsfree) intercom calls.
Ring Tone Selection 398 (Inter-Tel endpoints only) Selects the type of ringing alert tone that
will be heard from the endpoint.
Routing Off 304 Disables System OAI Offering Control for third-party aplications.
(This feature requires you to enter a password.) Once you disable
routing, you cannot enable it again (i.e., only the third-party appli-
cation can enable routing).
Station Monitor 321 (Hunt Group Supervisors only) Allows a designated hunt group
supervisor to monitor a call of anyone in the associated hunt
group.
Table 17. Station Feature Codes (Continued)
FEATURE NAME (CONTINUED) CODE DEFINITION (CONTINUED)