User guide

Page 108
System Hardware
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
Power Supplies
Model 8602: The Model 8602 IP softphone supports most of the features of the Model 8662
hard endpoint, except the following:
• Automatic Line Access On/Off (fc 360)
• Automatic Intercom Access On/Off (fc 361)
• Background Music On/Off (fc 313)
• Group Listen (fc 312)
• Handsfree On/Off (319)
• Headset On, Headset Off, Headset On/Off (fc 315, 316, 317)
• LCD Contrast Control (fc 303)
• Ring Tone Selection (fc 398)
• Switch Keymap (fc 399)
Feature Codes: The two feature codes in the table below function differently, depending on
the mode that the endpoint is operating in.
Voice mail displays: In SIP mode, voice mail displays are not supported, however, the user
will still receive audio prompts.
Power Supplies
Each SIP and IP device must use a compatible power supply. Because there are so many power
supply options, it is recommended that you refer to the IP Devices Power Supply Matrix
located in the IP Devices Installation Manual when selecting a power supply for the IP or SIP
device.
For more information about operating modes and IP devices, see the latest version of the
IP Devices Installation Manual (part number 835.2195).
Additional Information and Troubleshooting
For additional information about multi-protocol endpoints not covered in this administrator
guide, see the Multi-Protocol Endpoints: Supported Features, Buttons, and LED Indications
document (part number 835.2840). For detailed troubleshooting information, including trou-
bleshooting tables for SIP and IP devices, see the latest version of the IP Devices Installation
Manual (part number 835.2195).
Table 15:
Feature Code Exceptions
FEATURE NAME
FEATURE
CODE
ITP MODE SIP MODE
Show IP Address
Display Time/Date
300
Displays the system date
and time, username, and
extension.
Displays the IP address of
the endpoint.
Show Version
Diagnostics -Show Version
9928 or
9128 in Europe
Displays the version and
date of the call processing
software.
Displays the firmware ver-
sion on the endpoint.