Specifications

Chapter 4: Specifications
Digital Expansion Interface
Page 4-34 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Figure 4-2 shows the back of the PS-1 unit.
Figure 4-2. Processing Server (PS-1) Chassis, Back View
Digital Expansion Interface
This section describes the specifications of the Digital Expansion Interface (DEI) unit and the
modules that it supports—the Digital Endpoint Module (DEM-16) and the eight-port Single Line
Module (SLM-8).
DEI Unit
Physical dimensions of the DEI unit appear in Table 4-5.
A green power (PWR) LED on the front of the chassis indicates whether the DEI is plugged-in
to an active electrical circuit. Also, three sets of LEDs show the status of the three module bays.
The active status of each bay is shown by a green online (ON) LED and a yellow BUSY LED.
Three bays at the back of the chassis accept DEM-16 modules, and the following connection
interfaces are provided:
• The system power cord socket with built-in fuse holder (fuse is 250 V, 2 A). Power supply
requirements appear in “Power Supply” on page 4-7.
• Two DB-15 connectors. The 15-pin D-subminiature socket connectors provide electrical
interface to the Inter-Tel 5000 Base Server chassis and to either another DEI or an
optional, external Voice Processing Unit or Enterprise Messaging system.
• An earth ground lug.
Isolated, dedicated, single-phase commercial power source
Monitor
DB-15
Keyboard
Mouse
Power
(not included)
(optional)
Fan
or
RS-232 cable
Null modem
VGA
Connection
to monitor
with Hardware Flow Control (part number 804.2605)
RJ-45 to LAN
Connect to Laptop PC
PS-1
power cord
Monitor
power cord
USB Security Key
(Insert in any
USB port.)
USB ports
DB9M to DB9F Straight-through
(part number 813.1683)
On/Off
Switch
Table 4-5. DEI Physical Dimensions
Dimension Measurement (Metric)
Length 14.50 in. (36.83 cm)
Width 17.00 in. (43.18 cm)
Height 01.75 in. (4.45 cm) (1 U)
Weight 09.00 lb. (4.08 kg)