Specifications

Chapter 6: Programming
SLM-8 Programming Procedures
Page 6-148 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
To set up multiple, or batch, SLM-8 single line ports and circuit numbers:
1. Make sure an SLM-8 module is programmed in a system DEI.
2. Start the Inter-Tel 5000 Session Manager. The DB Studio window appears.
3. From the left pane of the DB Studio window, select System – Communication Server –
Digital Expansion Interface <DEI #: Single Line Module - 8>. When you click the
desired Bay n: Single Line Module - 8, the status of the SLM-8 ports appears in the right
pane. See Figure 6-25 ‘‘SLM-8 Single Line Ports and Circuits’’ on page 6-147.
4. Click the Port icon to the left of the first port number you want to use. The port number
field changes color and a drop-down box and arrow appear.
5. If the ports you want to program are in sequence, to select the batch of ports, press Shift
+ the final circuit in the batch you want. The selected port number fields change color. If
the ports are not sequential, hold down Ctrl and then select the desired port numbers
one at a time. The selected port number fields change color.
6. Right-click the top selected port number. The Batch Change Type... command button
appears, as shown in the following illustration.
7. Click Batch Change Type.... The Batch Change Type window appears (not shown).
8. Select the Single Line option button and click OK. The Create Single Line Extension
window appears, as shown in the following illustration.
9. Click the drop-down arrow, scroll to and select the Starting Extension from the list of
extension numbers, and click OK. Available sequential circuit numbers are assigned to
the selected ports and appear in the Circuit 1 column, where NONE appears prior to
assigning circuit, or extension, numbers. See Figure 6-25 ‘‘SLM-8 Single Line Ports and
Circuits’’ on page 6-147.