Specifications

Chapter 6: Programming
PCDPM Configuration in DB Programming
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 6-139
PCDPM Configuration in DB Programming
After the PCDPM hardware is installed, the telephone system database must be programmed
for the PCDPM intended purpose. For PCDPM installation instructions, refer to the Installation
chapter.
To configure DB Programming for PCDPM use:
1. Start DB Programming, then navigate to the System\Communication Server folder and
select the Digital Expansion Interface where the PCDPM is installed.
2. Set the following options:
• System Configuration: In the Digital Endpoint Module - 16 window for the DEI
where this PCDPM will be used, select the Port Type for the port assigned to the
PCDPM.
Figure 6-20. System Configuration
• Select Keyset if you plan on using the PCDPM as a DSS/BLF Unit connection or
for Off-Hook Voice Announce receive capability.
• Select Digital Endpoint/MDPM if attaching an MDPM to the PCDPM and you still
want to use the PCDPM for Off-Hook Voice Announce receive capability. The serial
connection on the PCDPM is not functional; therefore, Desktop Interface through
serial connections is not supported. Only the Mini-DSS is supported, and it does
not require a PCDPM.
Internet Protocol Resources
Depending on the system type you have, the Processor Module (CS-5200) appears and
provides IP resource configuration options. Or, if the Processor Expansion card has been
installed or you have a CS-5400 system, the Processor Expansion Card also appears providing
additional IP resources.
NOTE DB Converter provides a Help option with instructions for converting a database.