Specifications

Chapter 6: Programming
Selecting a Voice Processor Type in Local Mode
Page 6-110 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Selecting a Voice Processor Type in Local Mode
With v2.1 and later, when you enable a voice processor in local mode, you may be prompted to
choose a voice processor type. The Select a Voice Processor Type dialog appears only if you
have saved the database from a remote session that did not have the voice processor
physically connected. For the Mitel-recommended process, see “Saving a Voice Processor
Database in Remote Mode” on page 6-109.
The Select a Voice Processor Type dialog allows you to identify a known type of voice
processor that has not been enabled in the system configuration. It does not, however, allow
you to change a voice processor type after the database has been created.
To enable a voice processor in local mode:
1. Launch Session Manager and start a session of Database (DB) Programming.
2. From the left pane of the DB Studio main screen, select the System folder. Contents of
the System folder appear in the right pane.
3. Click the value of the Voice Processor Enable feature to Yes.
IMPORTANT
The “Select a Voice Processor Type” dialog appears only if you have,
from a remote session, saved the database of a system that does not
have a voice processor unit physically connected. Once the VP unit is
connected, the applicable VP function enabled, and a database saved
in a remote session, the Select a Voice Processor Type dialog does
not display again.
Voice Processor Enable Flag