Specifications

Chapter 6: Programming
Programming DEI Expansion Modules
Page 6-94 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
To configure the DEM-16 module:
1. Select Tools – Configuration Wizard.
2. Click Next in all dialog
boxes until you get to
the dialog box shown at
right.
3. Click Digital Endpoint
Module-16 from the
Expansion Modules
panel to select it.
4. Click Add >> to add it
to the Expansion Bays
panel.
5. To remove a module
from the panel, select
the module to remove,
then click << Remove.
This dialog box does
not support removal of
modules that are already physically installed in the chassis. Only modules added during
the current Configuration Wizard session may be removed.
6. Click Next.
7. All configurable
ports appear in the
Digital Endpoint
Module-16 Circuits
panel. The ports are
represented as
node:bay:port for
each DEM-16 you
added. Each port
may have up to two
circuits
programmed. If a
port contains any
devices
programmed before
this Configuration
Wizard session,
these ports cannot
be modified. Only
ports labeled as
None may be
configured.
Node:Bay:Port
IMPORTANT
Although a DEM-16 is physically residing in
DEI Bay 1, 2, or 3, it appears as 04, 05, or 06
in DB Programming to coincide with how
Message Print relates to this hardware in the
system. For more information, refer to the
Installation chapter.