Specifications

Chapter 6: Programming
Programming DEI Expansion Modules
Page 6-92 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Programming DEI Expansion Modules
Two system expansion modules can be installed in the DEI, the 16-port Digital Endpoint Module
(DEM-16) and the eight-port Single Line Module (SLM-8). The following procedures provide
instructions for programming these modules for the installation of digital and analog single line
endpoints, respectively. For module and endpoint installation procedures, refer to the Installation
chapter.
To configure a DEM-16 or SLM-8 module:
1. From the DB Studio menu bar, select Tools and then Configuration Wizard.
2. Click Next in all dialog boxes until the Digital Expansion Interface Configuration page
appears.
3. Select the System DEI Mode: 2-DEI Mode or 4-DEI Mode. The Expansion Module
Installation for DEI # <n> window appears.
4. Select Single Line Module - 8 from the Expansion Modules list, as shown in the
following illustration.
5. Click Add >> to add it to the Expansion Bays list. To remove a module from either
bottom panel, select the module to remove, then click << Remove. This dialog box does
not support removal of modules that are already physically installed in the chassis. Only
modules added during the current Configuration Wizard session may be removed.
6. Click Next.