Specifications

Chapter 6: Programming
Programming Expansion Modules
Page 6-86 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
9. After the desired ports and circuits have been configured, click Next to continue.
10. In a remote session, click Finish to confirm programming for the T1M-2. The software
license will be checked and you will be warned if the programming being implemented is
not supported by the software license.
T1/E1/PRI Module Programming
To configure circuits on a T1/E1/PRI Module:
1. From the Circuit Configuration page for the particular module you are setting up, select
the circuits you want to configure, and then click Change. To select all circuits, click
once to highlight the first circuit, and then SHIFT-click the second circuit to select the
range.
Depending on the modules installed and the order they reside in the chassis, this screen
could appear differently. This dialog box displays all modules of the same type (for
example, if all T1/E1/PRI modules are used). The first number indicates the bay
location).
NOTE
Ports and circuits configured prior to running the Configuration Wizard are
displayed, but cannot be changed in the wizard.
T1 PRI Module or E1 PRI Module selection
First number indicates
bay location (bay 1, 2, or 3).
Second number indicates
circuit type.