Specifications

Chapter 6: Programming
Programming Expansion Modules
Page 6-84 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
5. Select a port that has not yet been configured, and then click Configure. The Configure
button is disabled until you select a port. The Batch Change Type dialog box appears.
6. Select the desired port type, and then click OK. For ports with a type other than “None,”
selecting the port will display that port's circuits in the list view on the right.
IMPORTANT
DB Programming will display an error message under the following
circumstances:
• Change the port type of one port if the other port is programmed
(not None).
• Change the Framing Type under a T1 port and the other port is
programmed (not None). This field also exists under the T1/PRI
port type, but it is OLM only.
DB Programming displays: WARNING: Changes to this field are only
recommended on an idle system as this may cause a short pause in
audio on the other port of this module (but no dropped calls). Would
you like to continue?