Specifications

Chapter 6: Programming
Editing Existing IP Devices
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 6-79
Editing Existing IP Devices
The parameters of IP devices existing on a system can be changed as needed, including the
administrator endpoint (extension 1000) that is accounted for in the system’s default state.
To edit the provided administrator endpoint:
1. Right-click the administrator endpoint (1000) and select Edit MAC Address.
2. Enter a unique MAC address, and then click OK.
3. Click OK, click Next, and then continue to “Programming Expansion Modules” on page
6-80.
To edit existing device types:
1. Right-click the device type you want to edit. You can also CTRL click or SHIFT click
endpoint types to edit more than one of the same endpoint type at a time.
2. Select one of the edit options from the list. The options available depend on the device
type selected:
• Edit MAC Address. Type the MAC address for the device type selected.
• Batch Change Type. Change the device type from the list of available device types
listed in the Batch Change Type dialog box.
• Delete. Delete the selected device type(s). CTRL-click or SHIFT-click to select
more than one device.
• Create IP Device. Create and configure additional IP devices.
3. Do one of the following actions:
• Edit additional devices.
• Or, click OK.
4. When finished with editing parameters of IP devices, click Next on the IP Device Setup
page. The Expansion Module Installation page appears. Continue to “Programming
Expansion Modules” on page 6-80.
Administrator IP Endpoint
IP Endpoint
IP Single Line Adapter
MGCP Gateway and Endpoint
MGCP Endpoint
SIP Trunk