Specifications

Chapter 6: Programming
Process Summary
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 6-69
Process Summary
Complete the following high-level steps to set up the system with the Configuration Wizard:
1. Open the Configuration Wizard.
2. Configure the system’s general IP settings and IP settings for the Mitel CS-5200/5400/
5600 Base Server, Processing Server (PEC-1), and Processor Expansion Card (PEC-1),
as applicable.
3. Set up or edit parameters for the following IP devices:
• IP endpoints
• IP Softphone
• IP Single Line Adapter
• MGCP gateway and endpoint
• MGCP endpoint
• SIP trunk
4. Set up and program the following modules, as applicable:
• Base Server expansion modules
• DEI expansion modules
• Dual T1/E1/PRI modules
• T1/E1/PRI modules
• Loop Start modules
• Single Line modules
• Digital endpoint modules
5. Finish the Wizard configuration.
Running the Configuration Wizard
For quick reference and access to procedures that involve parent-child windows, the
Configuration Wizard has been grouped into subheadings for documentation purposes. In DB
Programming, the pages appear in
sequence without reference to the subheadings.
• “Opening the Configuration Wizard” on page 6-70
• “Programming Date and Time Settings” on page 6-71
• “Programming IP Settings” on page 6-71
• “Programming General IP Settings” on page 6-72
• “Programming IP Devices” on page 6-73
• “Editing Existing IP Devices” on page 6-79
• “Programming Expansion Modules” on page 6-80
o “BRM-S Module Programming” on page 6-81
o “Dual T1/E1/PRI (T1M-2) Module Programming” on page 6-83
o “T1/E1/PRI Module Programming” on page 6-86
o “LSM-2/LSM-4 Module Programming” on page 6-88
o “Single Line Module Programming” on page 6-89
• “Programming Digital Expansion Interface (DEI) Units” on page 6-91
• “Programming DEI Expansion Modules” on page 6-92
• “Finishing the Wizard Configuration” on page 6-96