Specifications

Chapter 6: Programming
Drag and Drop Operations: Inter-Tel Axxess Devices
Page 6-38 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Drag and Drop Operations: Inter-Tel Axxess Devices
Inter-Tel Axxess devices can be dragged and dropped into the Mitel 5000 view, as shown in the
following example, provided they meet the criteria discussed in this section. When the last
device is moved from the Inter-Tel Axxess view, the Inter-Tel Axxess card is removed from the
Data Form.
The following drag and drop locations in the Data Form Mitel 5000 view are supported for Inter-
Tel Axxess devices:
• Empty module, port, or folder (below)
• Empty device location (page 6-39)
• IP devices (page 6-39)
Figure 6-2. Inter-Tel Axxess to Mitel 5000 Connection for Inter-Tel Axxess Devices
To a Mitel 5000 Module, Port, or Folder
Any Inter-Tel Axxess device (or group of devices) displayed under a card in the Inter-Tel Axxess
view can be dragged and dropped onto a module, port or folder in the Mitel 5000 view. There
must be an available empty port/circuit on the module, port or folder in which that type of device
is supported. See Table 6-15, “DB Converter Supported Devices/Device Conversion,” on
page 6-28. If dragging and dropping a group, the operation is permitted if at least one device in
the group can be moved.
When the operation is completed, each dragged device is removed from the Inter-Tel Axxess
view and stored in the Mitel 5000 platform in the first empty location on the module, port or
folder. The view is automatically expanded (if not already) and the device type name is
automatically modified to the Mitel 5000 style (e.g., “Keyset” is changed to “Endpoint”).
If a group of devices is being copied, only those devices that are supported will be moved, and
if there is not room for all of the devices, one or more may be left behind and a message
appears.