Specifications

Chapter 6: Programming
Drag and Drop Operations: Inter-Tel Axxess Cards
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 6-35
Drag and Drop Operations: Inter-Tel Axxess Cards
Inter-Tel Axxess cards can be dragged and dropped into the Mitel 5000 view, as shown in the
following example.
Figure 6-1. Inter-Tel Axxess to Mitel 5000 Conversion for Inter-Tel Axxess Cards
Associated devices on those cards are moved as well, provided they meet the criteria
discussed in this section. The following drag and drop locations in the Data Form Mitel 5000
view are supported for Inter-Tel Axxess cards:
• Uninstalled bay or port (below)
• Empty module, port, or folder (page 6-37)
• IP devices (page 6-37)
To an Uninstalled Bay or Port
When an Inter-Tel Axxess card is dropped onto an uninstalled bay (or port) in the Mitel 5000
platform, the following operations take place:
• The card is converted to a Mitel 5000 module (or port) of the appropriate type as
described in Table 6-14, “DB Converter Supported Cards/Card Conversion,” on page 6-28
and Table 6-15, “DB Converter Supported Devices/Device Conversion,” on page 6-28.
In the case of a conversion to Mitel 5000 versions 2.3 or later, if a T1, T1/PRI, or E1/PRI
card is dropped onto an uninstalled bay, a T1/E1/PRI module is automatically created, and
the dropped card is installed in the port on that module. If desired, the module can then be
changed to a Dual T1/E1/PRI module, via right-click operations.