Specifications

Chapter 6: Programming
Database Conversion of a T1/E1 PRI Network
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 6-27
Database Conversion of a T1/E1 PRI Network
When converting an Inter-Tel Axxess database to a Mitel 5000 database, T1/E1 PRI networking
is converted intact, as long as you do the following using the DB Converter:
• Copy over the entire Inter-Tel Axxess T1/E1 card to the appropriate location on the Mitel
5000 side of the Dataform, keeping the B-Channel devices and all. As long as you copy
the card over, everything remains intact.
• Decide where you want the T1/E1 card to reside. For example, in which module (if using a
single T1/E1/PRI module) or port (if using dual T1/E1/PRI module).
For information on converting an Inter-Tel Axxess database to a Mitel 5000 database, see
“Converting a Database from Inter-Tel Axxess to Mitel 5000” on page 6-45.
For information on T1/E1/PRI Networking changes, refer to the Networking Wizard information
in the Mitel 5000 Features and Programming Guide, part number 580.8006.
DB Converter Error Messages
Error messages have been added for attempting to convert nonsupported databases or
conditions, as shown in Table 6-13.
Table 6-13. Database Converter Error Messages
Nonsupported Condition and Error
If an Inter-Tel Axxess database prior to v5.3 is chosen as the source file, the following error message appears:
If an Inter-Tel Axxess database of country type Japan or Mexico is chosen as the source file, the following error
message appears:
If an Inter-Tel Axxess database with a system size greater than 256 is chosen, the following error message
appears: