Specifications

Chapter 5: Installation

In Model 8520 or Model 8560 Endpoints

Mitel

5000 Installation Manual – Issue 3.0, October 2008 Page 5-211

Figure 5-74. PCDPM Installation in an Executive or Standard Display Endpoint

BACK OF DIGITAL ENDPOINTINSIDE OF BASEPLATE

If the endpoint will be wall-mounted, open

the back of the endpoint and reroute the

Module-to-Keyset Interface cable through

this knockout over to connector J3 on the

control board.

TO CHASSIS

HANDSET

PCDPM

RS232

CONNECTOR

MDPM

CONNECTOR

To Modem Data

TO DSS/BLF UNIT OR

PC/OUTPUT DEVICE

Older PCDPMs, part number 550.3014, require AC transformers when they are connected to DSS/BLF units

only. PCDPMs do not require AC transformers when they are used for off-hook voice announce only or have

attached MDPMs. For a diagram of AC transformer requirements, see Figure 5-73 on page 5-207. Also, some

early PCDPM-to-MDPM cables may have the stripe on the wrong edge. If the MDPM does not respond prop-

erly, try reversing the connector on the PCDPM.

Port Module