Specifications

Chapter 5: Installation

In Professional Display or Associate Display Endpoints

Mitel

5000 Installation Manual – Issue 3.0, October 2008 Page 5-209

In Professional Display or Associate Display Endpoints

To install a PCDPM in a Professional or Associate Display Endpoints:

1. Press up on the tabs and lift off the cover. Remove the cover and the display endpoint

foot in the back, as shown below.

2. Align the PC Data Port Module over the connector inside of the display endpoint and the

three pins on the outside. Gently press the module into place until the connector is

securely positioned into place, as shown below.

3. Attach the module to the display endpoint using the two mounting screws.

4. Plug the appropriate end of the PCDPM-to-MDPM interface cable, part number

813.1566, into the MDPM connector (J1), shown above, on the module. The other end

of the cable will later be attached to the MDPM after it is installed.

Pin 1 of the cable, indicated by the stripe on the edge of the cable, must correspond to

pin 1 on the MDPM connector, indicated by the notch silk-screened on the module.

BACK OF DISPLAY ENDPOINT

DISPLAY ENDPOINT

COVER

FOOT

BACK OF DISPLAY ENDPOINT

PCDPM