Specifications

Chapter 5: Installation
Installing a PCDPM
Page 5-206 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Installing a PCDPM
The following areas must be addressed to properly install and configure the PC Data Port
Module (PCDPM):
• Hardware Installation (discussed on the pages that follow)
o Executive Display or Standard Display Endpoint (page 5-208)
o Professional Display or Associate Display Endpoint (page 5-209)
o Model 8520 or 8560 Endpoint (page 5-210)
• System DB Programming (refer to the Mitel 5000 Features and Programming Guide, part
number 580.8006)
For Off-Hook Voice Announce (OHVA) receive capability, and to allow a DSS/BLF Unit and/or
Modem Data Port Module to be installed, any Standard, Associate, Executive, or Professional
Display endpoint or Model 8520 or 8560 endpoint may be equipped with a PC Data Port Module
(PCDPM). For the Executive and Standard Display endpoints, PCDPM part number 550.3018
[PB2585 in Europe] or 550.3014 [PB2548-A] is required. For the Professional and Associate
display endpoints, PCDPM part number 550.3018 is required. Models 8520 and 8560 endpoints
require PCDPM part number 550.8400.
The original model PCDPM, part number 550.3014 [PB2548-A in Europe], for the Executive
Display and Standard Display endpoints has been replaced with part number 550.3018
[PB2585]. The new PCDPM, part number 550.3018, and the Model 8520/8560 PCDPM, part
number 550.8400, do not require an external AC transformer. For details, see Figure 5-73 on
page 5-207. Refer to the installation instructions included with the unit. Procedures for installing
PCDPMs begin on page 5-208.
PCDPMs can be used for the following purposes:
• Receive capability for OHVA
• Connect Modem Data Port Module (MDPM)