Specifications

Chapter 5: Installation
Installing an External Voice Processing System
Page 5-194 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
6. Do one of the following:
• If installing the paging equipment on an endpoint speaker or the chassis paging
port:
a.) From an endpoint location, make a page by lifting the handset, pressing the
PAGE button (or dialing 7—the default Page feature code), and dialing a zone
code that includes the external paging zone or dialing the extension number
of the external paging port. The default is 91000.
b.) Adjust the amplifier to the desired level while placing the page.
• If installing the paging equipment on a LS circuit:
a.) Ensure that the LS circuit is not toll restricted.
b.) From an endpoint location, access the LS circuit and adjust the amplifier to
the desired level while placing the page.
Installing an External Voice Processing System
For integrated voice processing (voice mail, automated attendant, hunt group announcement
and overflow, optional Fax-On-Demand, buffered SMDR, Record-A-Call, etc.), an optional
external voice processing PC with special applications software can be attached to the system.
For additional voice processing information, refer to the voice processing information in the
Mitel 5000 Features and Programming Guide, part number 580.8006.
Introduction
An external voice processing PC is required for the Unified Messaging feature and to support
increased voice mail capacities. External voice processing is provided using an Enterprise
®
Messaging (EM) PC or NuPoint Messenger. For additional information about these external
voice processing systems, including installation, software installation and upgrading, see the
following documentation:
• Enterprise
®
Messaging Installation Manual, part number 780.8006.
• Mitel 5000 and NuPoint Messenger Integration Guide, part number 580.8008.
NOTICE
As personal computer (PC) technology evolves, Mitel continually enhances the design of its
voice processing systems. Depending on the actual version of equipment shipped for your
installation, the following instructions may vary. If revised instructions are included with the
equipment, see the most recent information.
WARNING
Possible Electric Shock. Use the LCD panel to shut down the system, then unplug the Mitel
CS-5200/5400/5600 Base Server, power cord before connecting the external voice
processing PC. The Mitel CS-5200/5400/5600 Base Server, power supply unit operates on
110 VAC and retains a charge after it has been turned OFF. Failure to allow the high voltage
to dissipate can cause bodily injury. Like the Mitel platform, the external voice processing PC
must have an isolated, dedicated, properly grounded AC circuit for proper operation and it
should be plugged into an UPS.
IMPORTANT
As with the Mitel 5000 system, the external voice processing PC must be
connected to an isolated, dedicated, properly grounded AC circuit and UPS
for proper operation. The UPS helps to avoid hard drive corruption in the
event of a power loss.