Specifications

Chapter 5: Installation
Processes and Procedures
Page 5-190 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
To configure the Base Server in DB Programming:
1. From the PS-1 IP address, start a DB Programming session.
• If a PS-1 is not connected to a Base Server, the Connection Wizard appears.
Follow the instructions in the Connection Wizard to make the Base Server–PS-1
Connection. When you click Finish, the Connection Wizard closes the DB
Programming session.
• To continue, restart the DB Programming session.
For details about using this wizard, refer to the Mitel 5000 Features and Programming
Guide, part number 580.8006. When you click Finish, the Connection Wizard closes the
DB Programming session.
2. Upload a Mitel CS-5600 license and any other system-specific licensing. From the DB
Studio menu bar, select Operations – Software License Operations – Upload Software
License. For the detailed procedure, see “Software License Upload” on page 5-99.
To reload system and voice mail databases:
For the tasks in this procedure, refer to the Mitel 5000 Features and Programming Guide, part
number 580.8006.
1. Restore the full database and voice processor data to the system.
2. Verify results.
3. Perform a full save of database and voice processor data after the upgrade is complete.
To verify that external clients point to the PS-1: During the installation and system bring-up
process, existing external clients should automatically re-set to point to the PS-1 IP address. To
avoid possible interruption of service, confirm satisfactory operation of all IP-connected clients.
To operate with the Mitel CS-5600, external clients must point to the PS-1 rather than the Base
Server. Clients include, but may not be limited to, OAI CT Gateway, OAI applications, Attendant
Console, System Manager, DB Programming sessions, external voice mail and Diagnostics
Monitor client sessions.
IMPORTANT
The license must match the system CPU type. A Mitel CS-5200
system requires a CS-5200 license; a Mitel CS-5400 system requires
a CS-5400 license; and, a Mitel CS-5600 system requires a CS-5600
license.
NOTE
To reduce the amount of programming changes to IP endpoints and remote nodes,
Mitel recommends that the CS-5X00 IP address should not change because IP
networking and IP endpoint configuration values continue to point at this IP address.