Specifications

Chapter 5: Installation
Wall-Mounting Model 8500, 8520, and 8560 Digital Endpoints
Page 5-136 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
To wall-mount Model 8000 Series endpoints with release buttons on bottom housing:
1. Close the base completely so that it lies flat against the endpoint. Rivet hole 1 on the
base aligns with the rivet hole on the bottom housing of the endpoint.
2. Plug the four-inch line cord into the jack on the back of the endpoint and thread the line
cord through the wall-mount knockout on the base.
3. Insert one of the plastic rivets in rivet hole 1 on the base (see illustration above) and
press it into the rivet hole on the endpoint. This locks the base to the endpoint.
4. Test the base to verify that it is securely locked to the endpoint.
5. Re-attach the metal plate to the endpoint base.
6. Insert the remaining plastic rivet through rivet hole 3 (as
shown at right) in the metal plate and press it firmly into
rivet hole 2 in the base. This locks the metal plate to the
base.
7. Plug the line cord into the jack on the wall-mount bracket
and position the endpoint securely on the wall-mount
bracket.
8. Flip the handset hanger down to the horizontal position
and lock it into place. This will hold the handset in place.
Rivet Hole
Base
Rivet Hole 1
Release Buttons
Bottom Housing
(Base not shown)
Rivet Hole 2
(Used to lock metal plate to base)
(Used to lock base to bottom housing)
Rivet Hole 3
Metal Plate