Specifications

Chapter 5: Installation
Wall-Mounting Model 8500, 8520, and 8560 Digital Endpoints
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 5-135
To wall-mount Model 8000 Series digital endpoints having a support mechanism:
1. Collapse the support mechanism completely and secure it against the bottom housing of
the endpoint, as shown below.
2. Close the base completely so that it lies flat against the endpoint. Make sure the two
rivet holes on the base align with the two rivet holes on the bottom endpoint housing.
3. Plug the four-inch line cord into the jack on the back of the endpoint and thread the line
cord through the wall-mount knockout on the base.
4. Test the base to verify that it is securely locked to the endpoint.
5. Insert the two plastic rivets through the metal plate and press them firmly into the holes
on the endpoint base. This locks the metal plate to the base.
6. Re-attach the metal plate to the endpoint base.
7. Plug the line cord into the jack on the wall-mount bracket and position the endpoint
securely on the wall-mount bracket.
8. Flip the handset hanger down to the horizontal position and lock it into place. This will
hold the handset in place.
The following instructions apply to endpoints that have release buttons located on the bottom
endpoint housing. To disengage the locking mechanism in the base, push in both buttons. To
lock the base in position, release the buttons.
Bottom Housing
Support
(Base not shown)
Mechanism
Base
Rivet Holes
Rivet Holes