Specifications

Chapter 5: Installation
Installation Options for Single Line Endpoints
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 5-127
Installation Options for Single Line Endpoints
AC—or tip/ring-controlled—single line endpoints can be installed using SLM-4 or SLM-8
modules, SLA or IP SLA units, the Data Device port on an MDPM attached to a digital endpoint,
or the two-port single line jack (RJ-14) built-in to the back of the Mitel CS-5200/5400/5600 Base
Server. Program the items discussed in these sections using information discussed in the
Programming chapter of the Mitel 5000 Features and Programming Guide, part number
580.8006.
Single Line Modules
If required, install an SLM-4 in the Mitel CS-5200/5400/5600 Base Server in accordance with
the standardized procedure, “Installing a Four-Port Single Line Module (SLM-4)” on page 5-55.
As applicable, program the endpoint in accordance with the procedure on programming a four-
port single line module in the Mitel 5000 Features and Programming Guide, part number
580.8006.
If required, install a SLM-8 module in the Digital Expansion Interface chassis in accordance with
the procedure, “Installing an Eight-Port Single Line Module (SLM-8)” on page 5-72. As
applicable, program the endpoint in accordance with the procedure on programming an eight-
port single line module in the Mitel 5000 Features and Programming Guide, part number
580.8006.
Single-Line Adapter (SLA)
If required, install an SLA in accordance with the procedure appearing at “Installing Single Line
Adapters (SLA)” on page 5-138.
IP Single-Line Adapter (IP SLA)
If required, install an IP SLA in accordance with the procedure at “Installing an IP SLA” on
page 5-198.
Modem Data Port Module
If required, install a PCDPM in a digital endpoint in accordance with “Installing a PCDPM” on
page 5-206. If required, connect an MDPM to the PCDPM in accordance with “Connecting
PCDPM Cables” on page 5-215.