Specifications

Chapter 5: Installation
IP PhonePlus and Model 8660/8620/8622/8662/8690
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 5-125
ID: XXXXXXXXXXXX
COULD NOT
CONTACT IP CARD
XXX.XXX.XXX.XXX
USING
UDP PORT XXXXX /
UDP-Failed Error Message: If the endpoint did not receive a response via UDP after
attempting to contact the IP resource (Mitel platform), the display will show this error
message for five seconds.
ID: XXXXXXXXXXXX
COUNT NOT
CONTACT IP CARD
XXX.XXX.XXX.XXX
USING
TCP PORT XXXXX /
TCP-Failed Error Message: If the endpoint did not receive a response via TCP after
attempting to connect to the IP card, the display will show this error message for five
seconds.
ID: XXXXXXXXXXXX
XXX.XXX.XXX.XXX
DUPLICATE IP
ADDRESS AT
MAC ADDRESS:
XXXXXXXXXXXX
Duplicate-IP Error Message: If the endpoint determined that some other device is
using the IP address that it is trying to use, the display will show the error message for
thirty seconds. The display shows the IP address the endpoint is trying to use, that the
address is in use by another device, and the MAC address of that device.
DSP FAILURE
DSP Failure: The application code displays the DSP Failure message if there was an
error (bus error) while accessing the DSP. If this occurs, try two or three downloads
before returning the endpoint for repair. After two or three failed attempts, send in the
endpoint for repair.
DSP NOT RUNNING
DSP NOT RUNNING
DSP Not Running: The application code displays the DSP Not Running message if the
endpoint was able to access the DSP but has not received any response from the DSP
(no online interrupt). If this occurs, try two or three downloads before returning the
endpoint for repair. After two or three failed attempts, send in the endpoint for repair.
WAITING FOR
ETHERNET
ADDRESS
Waiting for Ethernet Address: The application code has detected that the endpoint
does not have a valid Ethernet address. If this occurs, try two or three downloads before
returning the endpoint for repair. After two or three failed attempts, send in the endpoint
for repair.
Table 5-19. IP PhonePlus and Model 8660/8620/8622/8690 Progress Displays (Continued)
Display Status