Specifications

Chapter 5: Installation
Wall-Mounting IP Endpoints
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 5-115
Wall-Mounting IP Endpoints
See the following sections for information about wall-mounting your specific endpoint type.
Model 8600 Series Endpoints
Because there are two types of bases used on the Model 8600 series endpoints, two sets of
instructions for wall-mounting the endpoints are included here. Determine which type of base
the endpoint has and follow the appropriate instructions.
For best results when wall-mounting the Model 8600 series endpoints, Mitel strongly
recommends that you use the two plastic rivets shipped with the endpoint. Once installed, the
plastic rivets lock the components into place, providing additional stability for wall-mounted
endpoints.
Model 8600 series endpoints are shipped with a plastic adhesive label that covers the
rectangular wall-mount knockout on the base of the endpoint. A portion of the adhesive label
must be removed to use the wall-mount knockout.
To wall-mount the Model 8600 series endpoints, you need an industry-standard wall-mount
bracket (sometimes called a wall jack assembly) and a four-inch line cord. Both of these items
are available through the Mitel CommSource division.
NOTE
Wall-mounting the Model 8600 series endpoints is not recommended if the user will
be connecting and disconnecting cords (handset, headset, line) and/or cables
(Ethernet, USB, power supply) frequently. To connect and disconnect these cords
and cables from a wall-mounted endpoint, users will need to remove the endpoint
from the wall.
Wall-Mount Knockout
Base