Specifications

Chapter 5: Installation
Eclipse IP PhonePlus
Page 5-114 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Eclipse IP PhonePlus
The Eclipse IP PhonePlus operates on either 10Base-T or 100Base-T LANs, while the Mitel
5000 platform operates only on 100Base-T LANs. The following illustration depicts the
connection interfaces on the bottom and back of the endpoint.
The Eclipse IP PhonePlus provides the following connection interfaces:
• LAN/POWER Jack: Connects to an external power supply or a network hub/switch.
• Barrel Jack: Connects to an external power supply.
• Ports 1, 2, and 3 (OUT TO PC Jack): Connects up to three other IP devices, such as
PCs, notebooks, and printers.
• LEDs: Two LEDs indicate activity on each port:
o Link Status: When the link is valid, the green LED on the left side of the port lights.
When receive or transmit activity occurs on the link, the LED flashes.
o Collision: When both receive and transmit activities occur on the link at the same time,
the yellow LED on the right side of the port lights.
• Handset Jack: Connects to a handset.
For information about programming an Eclipse IP PhonePlus, refer to the Programming chapter
in the Mitel 5000 Features and Programming Guide, part number 580.8006.
DC
Barrel Jack
HANDSET Jack
The center
PORT 3
LAN/
PORT 1 PORT 2
Bottom
LEDs
Back
POWER
is positive.