Specifications

Chapter 5: Installation
Hardware Revision Identification
Mitel
®
5000 Installation Manual – Issue 3.0, October 2008 Page 5-107
Hardware Revision Identification
Check the following areas to identify endpoint hardware types:
• Endpoint Web Interface: The hardware type is displayed in the Firmware Information
field under Status – Firmware – Hardware Type.
• LCD (Liquid Crystal Display): The hardware type is displayed on the bottom line of the
LCD on startup.
• Product ID and Revision: The part number and revision are displayed on the labels on
the bottom of the endpoint.
• Message Lamp LED (Light-Emitting Diode) Pattern: The hardware type is identified by
the message lamp LEDs during startup. The user must reset the endpoint first.
• Ethernet Ports: The number of Ethernet interfaces can be used to identify the hardware
type.
Table 5-14 on page 5-107 lists the hardware types and identification methods.
Table 5-14. Hardware Revision Identification
Endpoint
Hardware
Type
LCD
Product ID
(p/n)
LED Pattern
Ethernet
Port
Model 8600 — original 8600 Not
Available
550.8600 The endpoint LEDs
flash in a left-right
alternative blinking
pattern.
1 Port
Model 8620 — original 8620 8620 550.8620 Not Available 1 Ports
Model 8622 — original 8622 8622 550.8622 Not Available 2 Ports
Model 8662 — original 8662 8662 550.8662 Not Available 2 Ports
Model 8662 — enhanced 8662 8662 550.8662E Not Available 2 Ports
Model 8600 — enhanced,
redesigned
8600v2 Not
Available
550.8600 The endpoint performs
a blinking LED pattern
of the XFER, CNF,
MSG, FWD, and DND
button LEDs.
1 Port
Model 8622 –
enhanced, redesigned
8622v2 8622v2 550.8622 Not Available 2 Ports
Model 8662 –
enhanced, redesigned
8662v2 8662v2 550.8662E Not Available 2 Ports
Model 8622 — PoE Class 2 8622 8622 550.8622P Not Available 2 Ports
Model 8662 — PoE Class 2 8662 8662 550.8662P Not Available 2 Ports