Specifications

Chapter 5: Installation

Replacing the Power Fuse

Page 5-102 Mitel

5000 Installation Manual – Issue 3.0, October 2008

Replacing the Power Fuse

The Inter-Tel 5000 Base Server has a replaceable power fuse, part number 802.2028. The fuse

is located above the power cord connection on the back of the chassis, as shown in Figure 5-

49.

Figure 5-49. Base Server Chassis Power Fuse

To replace the power fuse:

1. Perform a Database backup—for details, refer to the Mitel 5000 Features and

Programming Guide, part number 580.8006. You can also back up the database using

the LCD panel—see page 5-34.

2. Perform a voice processing database backup. With the Mitel CS-5200 and CS-5600

running BVM, Mitel recommends using a USB flash drive attached to the USB-A port on

the front of the Mitel CS-5200/5400/5600 Base Server chassis. Do not back up VM to

the compact flash-type memory card. For the backup procedure, refer to the Mitel 5000

Features and Programming Guide, part number 580.8006. For a list of USB flash drives

that have been tested as compatible with the system, see “USB Flash Drives” on

page 4-25.

3. Shut down the system using the LCD panel. See Figure 5-14 on page 5-34 for an

illustration of the menu locations.

4. Unplug the power cord.

5. Remove the fuse from above the power connection at the back of the chassis, then

replace the fuse.

6. Make sure the fuse is seated correctly, then connect the power cord. The system powers

up and begins the boot process.

Chassis Back

Fuse

2- Line LCD Panel LCD Panel

Chassis Front

Controls

Power