Specifications

Chapter 5: Installation
PS-1 Hardware
Page 5-58 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
PS-1 Hardware
This section provides line drawings of the front and back views of the PS-1 chassis.
Figure 5-28. Processing Server (PS-1) Chassis, Front View Without Cover
Figure 5-29 shows the back of PS-1 units.
Figure 5-29. Processing Server (PS-1) Chassis, Back View
NOTE
The On/Off button switch on the front of the chassis controls power to the system.
The On/Off switch on the back should remain On at all times.
DVD
Compact Disk (CD) drive tray
(Use for initial installation
USB Port
and for system recovery)
+
On/Off
Switch
Power
Green LED
indicates
Active
Hard Drive
Blue LED
indicates
Power On
Fans
Reset
Button
System
(Use for USB Security Key
ONLY if cover is open
or not attached.
See Back View.)
NOTICE
Accidental System Reset Hazard. Do not mount the PS-1 in a rack directly above the Base
Server. If you do, pulling down the front cover (not shown) of the PS-1 may cause the edge
of the cover to press the three middle buttons on the LCD panel controls, causing the system
to reset. If you mount the PS-1 in the same rack as the Base Server, make sure the hinged
front cover of the does not open onto the front of the Base Server. Mitel recommends
mounting the PS-1 below or away from the Base Server and Digital Expansion Interface
(DEI) units.
Isolated, dedicated, single-phase commercial power source
Monitor
DB-15
Keyboard
Mouse
Power
Switch
(not included)
(optional)
Fan
or
RS-232 cable
DB9M to DB9F Straight-through
On/Off
Null modem
VGA
Connection
to monitor
with Hardware Flow Control (part number 804.2605)
(part number 813.1683)
RJ-45 to LAN
Connect to Laptop PC
PS-1
power cord
Monitor
power cord
USB Security Key
(Insert in any
USB port.)
USB ports