Specifications

Chapter 4: Specifications
Endpoint LED Flash Rates
Page 4-48 Mitel
®
5000 Installation Manual – Issue 3.0, October 2008
Endpoint LED Flash Rates
Table 4-4 on page 4-6, Table 4-5 on page 4-8, and Table 4-6 on page 4-10 describe the LED
flash rates for IP endpoints in ITP and SIP mode in interruptions per minute (IPM). For more
general information, refer to the Inter-Tel 5000 Features and Programming Guide, part no.
580.8006.
Table 4-16. Multi-Protocol Endpoint LED Flash Rates, ITP Mode
Steady
0 IPM
Slow
30 IPM
Medium
120 IPM
Fast
240 IPM
Flutter
60/960 IPM
CALL
Call is active Call is recalling
from hold or
transfer
Call or queue
callback is ringing
in or camped on
(waiting)
Call is on hold at
the user’s
endpoint or the
user has entered
a transfer feature
code.
1
CNF
Conference is in
progress.
Conference is
recalling your
endpoint.
A conference
party is on
conference wait
hold.
DATA
2
Auto-dial modem
is dialing and the
data port is
unavailable. (Red
LED)
Ring signal is
being sent to the
data device.
Data call is in
progress and
accessible. A
continuous flutter
indicates that the
data device is off-
hook.
DND
Endpoint is in Do-
Not-Disturb.
MINI-DSS
2
The programmed
endpoint in busy
or unplugged.
The programmed
endpoint is in
DND.
The programmed
endpoint has a
call ringing in.
Continuous flutter
indicates that the
programmed
endpoint was left
off-hook.
FEATURE
2
The feature is in
use.
FWD
Calls are being
forwarded.
HUNT GROUP
All endpoints in
hunt group are
unavailable.
Hunt group has a
call camped on.
IC
Intercom call is in
progress.
Recalling
intercom call is
camped on
(waiting).
Intercom call is
camped on
(waiting).
An intercom call
is on hold at the
user’s endpoint
or the user has
entered a transfer
feature code.
1
MSG
Endpoint is in
alpha-numeric
mode.
Message is
waiting.
MUTE
Microphone is
muted.